OMG Heavy Duty Roofing Fasteners (#14) are designed to secure insulation to steel (18 to 22 Ga.), wood and structural concrete decks. They can also be used to secure membrane to wood and concrete decks. Available in lengths from 1 1/4-in. - 24-in. Factory Mutual and Dade County approved.
Features & Benefits
- Heavier shank & thread diameters than most “heavy duty” roofing fasteners.
- Deep thread for high pullout resistance.
- Extra sharp spade point for quick installation in new or reroof applications.
Steel & Wood Decks - The fastener must penetrate steel and wood decks a minimum of 3/4-in.
Structural Concrete Decks - The fastener must penetrate structural concrete decks a minimum of 1-in. Pre-drill a 3/16-in. pilot hole at least 1/2-in. deeper than fastener embedment using a carbide tip SDS or straight shank bit.
Drive the fastener until a slight depression is seen around the plate, or with very rigid insulation boards, watch for the plate to dimple.
Prior to job-start, contact OMG to perform a pullout test to determine pullout values
NOTE: Care must be taken not to overdrive the fastener causing subsequent damage to the insulation facer. The fastener must be tight enough so that the plate does not turn.
Thread Diameter: .245-in. (6.2mm)
Shank Diameter: .190-in. (4.8mm)
Head Diameter: .435-in. (11mm)
Head Style: #3 Phillips Truss Head (#3 phillips bit included)
Coating: OMG CR-10 corrosion resistant coating passes the corrosion requirements of FM Approval Standard 4470 and EAD 030351-00-0402.
|Cat. No.||Length (in)||Thread (in)||Packaging||Weight (lbs)|